IC Realtime Specialty: Interrogator DVR - a DVR for law enforcement - Manual (Page 106)

106
— Record channel: Here you can select record channel (Multiple choices). Please
make sure you have set MD record in encode interface(Main Menu->Setting-
>Schedule) and schedule record in manual record interface(Main Menu->Advanced-
>Manual Record)
— Period: Here is for you to set record period. Click set button, you can see an
interface is shown as in Figure 7-44. In Figure 7-44, click time set button, you can
see an interface is shown as in Figure 7-45. Here you can set time period.
— Sensitivity: There are six levels. The sixth level has the highest sensitivity.
— Region: If you select motion detection type, you can click this button to set motion
detection zone. The interface is shown as in Figure 7-46. There are
PAL22X18/NTSC22X15 zones. Right click mouse you can go to full-screen display
mode. Do remember clicking OK button in Figure 7-46 to save your motion
detection zone setup.
— Anti-dither: system support anti-dither function. The value ranges from 0 to 15
seconds.
— Alarm latch: After alarm completes, system can still alarm for the specified time. The
value ranges from 10 to 300 seconds.
— Record latch: After motion detection completes, system can still record for the
specified time. The value ranges from 10 to 300 seconds
— Mail: system can send out email to alert you when alarm occurs.
— Tour: Here you can enable tour function when alarm occurs in corresponding
channel. System supports multiple-window tour. Please go to chapter 5.3.9 Display
for tour interval setup.
— PTZ activation: Click set button, you can see an interface is shown as in Figure 7-47.
System can go to corresponding preset when alarm occurs.
Figure 7-43