Great Planes CAP 232 1.60 ARF - GPMA1410 - Manual (Page 23)

❏
1. Remove the stopper from the included fuel tank and
replace it with a gas safe stopper such as the Sullivan #484
(SULQ2684) or Dubro #400 (DUBQ0675).
❏
2. Assemble the stopper using Du-Bro #813 1/8" [3.2 mm]
I.D. fuel line barbs (DUBQ0670) and 1/8" [3.2 mm] brass
tubing as shown. Solder the barbs to the brass tubing but be
careful not to overheat the assembly as it could cause
damage to the rubber stopper.
❏
3. Attach gasoline safe fuel line with clunks to the tubing
as shown; remember to bend the vent line upwards towards
the top of the fuel tank. The clunks should move freely. One
clunk is for the fill line and one is for the carburetor line.
❏
1. Locate the fuel tank. The hardware needed for the fuel
tank assembly is inside of the tank. Remove the stopper and
shake out the contents.
❏
2. The fuel system for the CAP 232 uses three lines. There
is a fill line, carb line, and vent line (to muffler). The fill line will
allow fueling without removing the cowl.
❏
3. Slide the three aluminum fuel tubes into the rubber
stopper as shown.
❏
4. Cut the fill line and carb line tubes so that the tubes
extend 1/2" [13 mm] out from both ends of the stopper. The
vent line should be bent upwards and left uncut.
❏
5. Attach silicone fuel lines 6" [153 mm] in length to the
fill and carb tubes on the stopper. Install fuel clunks on each
of these lines.
Glow Stopper Assembly Gas Stopper Assembly
23