GME GP450XB - Manual (Page 23)

GP450X INSTRUCTION MANUAL PAGE 23
trIP: Trip distance WPt: Range and bearing to
Waypoint .
tImE: Time and date
XtE: Cross track error
PosN: Position.
ttG: Time to go (to
destination) .
PoWEr: Power source
voltage .
Eta: Estimated time of
arrival (at destination) .
7 . Repeat to select options for the other available
field locations .
8 . When finished, press the mENu key twice to return to the
navigation screen . The Digital display options you selected
will now be available when the dIsP key is cycled .
sPEEdomEtEr
Select Speedometer to calibrate and display an analogue
speedometer on the User Display .
1 . T he start from field is highlighted . Here is where you
calibrate the Speedometer . Press the ENt key to begin .
2 . Use the cursor keys to enter the minimum speed you want
the speedometer to display . Press the or keys to change
the value at the cursor position and the or keys to move
the cursor to the left or right . The range can be set from -99
to +99 . Press the ENt key when done .
3 . The Interval field is highlighted . Press the ENt key .
4 . Use the cursor keys to enter the speedometer scale interval .
The range can be set from 1 to 99 . Press the ENt key
when done .
Note: The resulting speedometer scale is displayed at the
bottom of the screen .
5 . Press the mENu key twice to return to the navigation screen .
The Speedometer display options you selected will now be
available when the dIsP key is cycled .
resetting trip and odometer distances.
1 . At the main menu, select ErasE and press the ENt key .
2 . Select the rEsEt trIP? field and press the ENt key . The
Reset Trip Meter window is displayed .
3 . Choose yEs and press the ENt key . The Trip meter is reset
to 0 .
4 . Select the rEsEt odo? Field and press the ENt key . The
Reset Odometer window is displayed .
5 . Choose yEs and press the ENt key . The Odometer is
reset to 0 .
6 . Press the mENu key twice to return to the navigation screen .
clEarING data
You may clear GPs data, menu settings and all backup data to
start afresh .
1 . From the main menu select ErasE and press the ENt key .
2 . Select from GPs data, mENu sEttING or all BackuP
data and press the ENt key .
3 . One of the following messages appears;
4 . Choose yEs and then press the ENt key . A beep sounds
while the selected item is being erased .
NotE: If you were using the simulation mode, when data is
cleared, the message start simulation - are you sure?
appears . Choose yEs and press the ENt key to restart the
simulation mode, or press the ENt key to select No and start
normal operation .
NotE: When the memory is cleared the GP450X is restored to
a default position as shown in the table below .
language default
Position units time
difference
English N 22° 47,
E115° 22 nm, kt 0:00
German N 54°,
E10° nm, kt 0:00
French N48° 52,
E2° 18 km, km/h 0:00
Spanish N40° 26,
W3° 40 nm, kt +2:00
Chinese N22° 47,
E115° 22 nm, kt +8:00
Example of the sPEEdomEtEr user display
Minimum
Speed
Speed
Interval
Minimum Speed Speed Interval