Activating the noise reduction (picture) control, More pip (picture-in-picture) connections, Connect the cable out on – Philips COLOR TV User Manual
Page 23: Connect the video out jack, Connect the audio out
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
ctivating
the
N
oise
R
eduction
(P
icture
) C
ontrol
F
or reasons such as poor cable
reception, the picture can some
times appear slightly “speckled” (or
signal noise shown in the picture). The
NOISE REDUCTION control can help
eliminate this type of interference and
improve the quality of the picture.
( BECIIM]
j rei
Press the
MENU
button
on the
remote to display the onscreen menu.
Press the CURSOR UP ^ or
CURSOR DOWN ■ button
until the
words
NOISE REDUCTION
are
highlighted.
Press the CURSOR RIGHT
or CURSOR LEFT ^ but
tons
to activate or deactivate the
Noise Reduction Feature.
S
m a r t
H
elp
Remember: The onscreen
M menu will disappear in a few
seconds after you have finished your
adjustment.
“Noise” Reduction is a video adjust
ment feature that affects the picture
quality of the TV not the sound.
COL.
TEMP
NORMAL
CONTRAST PLUS ON
NOISE REDUCTION OFF
VOLUME
BALANCE
15
0
COL. TEMP
NORMAL
CONTRAST PLUS
ON
I NOISE REDUCTION
ONI
VOLUME
■■ 15
BALANCE
..... I- .... □
M
ore
PIP
(P
icture
-I
n
-P
icture
) C
onnections
P
IP hookup with a Cable Box
and VCR.
(BECIN)
First use an optional signal
splitter and
connect the original
cable TV signal to both the CABLE
IN on the Cable Converter and the
75Q plug on the rear of the televi
sion.
Connect the CABLE OUT
on
the Converter to the ANT IN on the
VCR.
Connect the VIDEO OUT jack
on the VCR to the VIDEO AVI jack
on the TV.
Connect the AUDIO OUT
(right and left) jacks from the VCR
to the AUDIO AVI (right and left)
jacks on the television.
Contact the Parts
Information Center
at 1-800-851-8885
to order any optional
accessories.
CABLE TV CONVERTER
41