Philips COLOR TV - Manual (Page 15)

il
U nderstanding the S mart L ock ™ C ontrol (A ccess C ode S etting the R emote C ontrol T o W ork W ith O ther D evices
/^ver the next few pages you’ll
learn how to block channels
and get a better understanding of
the rating terms for certain pro­
gramming.
First, let’s start by learning how to
set a personal access code:
C beoin J
<$> Press the MENU button on the
remote to display the onscreen
menu.
<|> Press the CURSOR UP ► or
CURSOR DOWN ■ buttons until
the words SmartLock are highlight­
ed.
Press the CURSOR RIGHT
button to display the
SmartLock Access Code screen.
Using the NUMBERED but­
tons, enter 0,7,1,1. “XXXX”
appears on the Access Code screen
as you press the numbered buttons.
“INCORRECT CODE” will
appear on the screen, and you will
need to enter 0,7,1,1 again.
<§> Press the CURSOR DOWN ■
button until the words CHANGE
CODE are highlighted.
<è> Press the CURSOR RIGHT
button to change your per­
sonal Access Code.
“Next enter a “new” 4 digit
code using the NUMBERED
buttons. The screen will then ask
you to confirm the code you just
entered.
Enter your new code
again. “XXXX” will appear when
you enter your new code.
Press the STATUS/EXIT but-
ton after the new code has been
entered to set the code in the TV's
memory.
INPUT
SLEEPTIMER
►
OFF
[SmartLock
CLOCK ►
CC OFF
SmartLock
ACCESS CODE
SmartLock
ACCESS CODE
X X X X
SmartLock
ACCESS CODE
INCORRECT CODE
BLOCK
/
►
[CHANGE CODE ► [
NOTE: The 0,7,1,1 access code shown
on this page is the default code or a
way to reset the code when the current
access code is not known.
Parents - it isn’t possible for your child
to unblock a channel without knowing
your access code or changing it to a new
one. If your code changes, and you did­
n’t change it, then you know it’s been
altered by someone else and blocked
channels have been viewed.
Search Method
F our TV remote can be set to
work various external devices
such as VCRs, Cable Boxes,
Satellite Receivers, DBS, etc. by
what is called the search method of
remote control programming. If the
“DIRECT ACCESS” code number
method (shown on the previous
page) did not set your remote to
work your accessory device, then
follow the easy steps listed below.
Note: The Search Method only
works with devices equipped with
channel display indicators or
capability.
Please read steps 1-4 before begin­
ning.
CBEGINI
Press the POWER button on
the device your are attempting to
program to turn it ON.
Place the TV/VCR/ACC
Mode Switch in the proper posi­
tion.
Press the (A/CH) • RECORD
^^and the SMART SOUND but­
tons simultaneously and hold them
down.
The device will begin to change
channels after the remote identi­
fies the correct code. When the
channels start to change release the
VCR RECORD and SMART
SOUND buttons. The remote
should be ready to operate the
device.
I / S mart H elp
This method can take up to
fi two minutes to perform.
Don’t let the device scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search cycle
will have to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4.
Should a channel change still not
occur, the remote will not work the
desired device.
Satellite Receiver
16 33