Adjusting the pip tint, Setting the tv’s clock, Press the cursor up ► or the cursor down ■ button – Philips COLOR TV User Manual
Page 22: Press the clock button on, Pip t
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
djusting
the
PIP T
int
S
etting
the
TV’
s
C
lock
'T^he Picture-In-Picture (PIP)
J. Tint control is used to make fine
tune adjustments to the tint setting
for PIP (when it is shown on the TV
screen).
( BEGIISI)
Press the
MENU
button
on the
remote to show the onscreen menu.
Press the CURSOR UP ► or
the CURSOR DOWN ■ button
until the word
PIP
is highlighted.
<|> Press the CURSOR RIGHT
button
to display the PIP
TINT control.
Press the CURSOR RIGHT
or the CURSOR LEFT
buttons
to adjust the TINT bar to
the desired levels.
Press the STATUS/EXIT but
ton
to clear the menu from the
screen when the adjustment is com
plete.
(0:
S
mart
H
elp
Remember, although
^ there is a separate TINT
control for PIP, the adjustment lev
els for this control depend on the
TV’s main picture. For example: If
the main picture screen is showing
a black and white picture, PIP
would also be seen in black and
white (even though the PIP picture
source is in color).
CLOCK
CC
► '
OFF
fpip
► 1
SETUP
►
SmartLock REVIEW
►
POWER
0
rTV RECORD
rUS/EX(T CC CLOCK
3 0 0
I---©
®
®
4
®
!^ iO )
® A
m
a
SWAP SOURCE POSmON FREEZE
O O O O
o"
y
our television comes with an
onscreen clock. During normal
operation the clock appears on the
screen when the STATUSIEXIT but
ton is pressed or when a channel
change occurs.
C
begin
J
Press the CLOCK button on
the remote to display the onscreen
CLOCK menu.
Press the CURSOR UP ► OR
CURSOR DOWN ■ buttons
until
the words
SET CLOCK
are high
lighted.
Enter the current time using
the NUMBERED buttons.
If the
first number is a single digit first
enter a zero then the digit (i.e.,
press “0”, then press “8”).
Press the CURSOR RIGHT
^ or CURSOR LEFT ^ but
tons
to set either
AM
or
PM
time.
Note:
The
CLOCK
onscreen menu
can also be accessed through the
main menu by
pressing the MENU
button; then scrolling up/down
with the CURSOR UP ^ or
CURSOR DOWN ■ buttons
until
the word
CLOCK
is highlighted.
Press the CURSOR RIGHT ^
button
to activate the CLOCK
menu and follow the steps above to
set the time.
S
mart
H
elp
Remember: Be sure to
i press “0” first and then the
hour number for single digit
entries.
To clear the onscreen menu press
the STATUS/EXIT button, or wait
a few seconds after you have fin
ished your adjustment and the
menu will automatically disappear
from the screen.
40