Philips COLOR TV - Manual (Page 19)

S etting the TV’ s S tart U p T ime
T Tsed along with the Clock fea-
Cy ture, you can select a specific
time the television will turn on
when the Timer Active control is
turned ON.
CBEGlif)
Press the CLOCK button to
I display the Clock onscreen menu.
Press the CURSOR UP ► or
CURSOR DOWN ■ button until
the words START TIME are high­
lighted.
Enter the time to turn on the
TV using the NUMBERED but­
tons. If the first number is a single
digit first enter a zero then the digit
(i.e., press “0”, then press “8”).
Press the CURSOR RIGHT
or CURSOR LEFT but­
tons to set either AM or PM time.
S mart H elp
Remember: Be sure to set
S the Timer Active to ON.
TIMER ACTIVE
CHANNEL
START TIME TIMER ACTIVE
CHANNEL
□N
12
START TIME 08:30 AM
12 8:30
SWAP SOURCE POSITION FREEZE o o o o
PIP ON/OFF
o
If the TV is in use when the START
TIME control is about to be activated, the
screen will display a warning stating it's
going to change channels in 30 seconds.
It will appear like the screen shown below
and change to the selected start up chan­
nel. Pressing any button on the remote
within this count down will cancel the
change.
CHANGING
TO CHANNEL 6
IN 30 SECONDS
12
U sing the PIP (P icture -I n -P icture ) F eature
Hooking up PIP
Picture-In-Picture (PIP) is the show­
ing of two pictures on the TV screen
at the same time. (One main screen
picture and one small inset picture -
or PIP).
Please Note: A VCR (or Accessory
Device) is needed to supply the PIP
signal.
The follow steps describe the basic
hookup needed to use PIP:
C BEGIN]
<1> First use an optional signal
splitter and connect the original
cable TV signal to both the
CABLE/ANT IN on the VCR and
the 75Q input jack on the rear of the
television.
<|> Connect the VIDEO OUT jack
on the VCR to the VIDEO AVI jack
on the TV.
Connect the AUDIO OUT
(right and left) jacks from the
VCR to the AUDIO AVI (right and
left) jacks on the television.
Be sure to turn the VCR ON while
using the PIP features. The signal
supplied through the VCR will
appear in the PIP window once the
PIP Source has been selected.
Please refer to the next page to learn
ho to set the PIP Source control.
OPTIONAL TWO-WAY SIGNAL
(single 75 ohm Input to twin 75
ohm Outputs - optional RF
Coaxial connecting cables also
required) ROUND CABLE
75 OHM
S mart H elp VCR WITH AUDIOmOEO OUPUTS
For other possible PIP
S connections see pages 41-42
for the “More PIP Connections”
section.
If you need any accessories or parts
to complete the described PIP con­
nections, contact your dealer, or our
Parts Information Center at:
1-800-851-8885
37