Futaba 8FG 2.4GHz - Manual (Page 91)

91 0RGHO0HQX$LUSODQH*OLGHU)XQFWLRQV!
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
RTN button.
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR ELEVATOR 2
AILVATOR
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
&0%)/3WR(/( [Corresponding model type]: Airplane/glider,
DLOHURQV ÁDS RU PRUH
:KHQ WKH FDPEHUVSHHG IODSV DUH XWLOL]HG
WKHDLUFUDIWPLJKWH[SHULHQFHDFKDQJHLQSLWFK
This mix compensates for such changes by
incorporating elevator input.
ŏ 7KH HOHYDWRU VHUYRV XSGRZQ UDWHV FDQ EH
adjusted separately. If the mixing direction is
reversed, change the mixing rate polarity (+ or –).
ŏ 0L[LQJ GXULQJ IOLJKW FDQ EH WXUQHG 212)) E\
setting a switch. (Always ON at [--] setting)
ŏ ( O H Y D W R U U D W H
adjustment
6HWWLQJPHWKRG
Ɣ$FWLYDWHWKHIXQFWLRQ
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
touch sensor.
*The display blinks.
T o u c h t h e R T N b u t t o n t o a c t i v a t e t h e
function and return to the cursor mode. (ON
is displayed.)
When setting a switch, move the cursor to
the [SW] item and touch the RTN button to
call the selection screen. Select the switch
and set its ON direction. (Always ON at "--"
setting)
)RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQPHWKRGVHHWKH
description at the back of this manual.
Ɣ0L[LQJUDWHDGMXVWPHQW
Move the cursor to the RATE1 or RATE2 item
and touch the RTN button to switch to the
data input mode. Adjust the mixing rate
independently by scrolling the touch sensor.
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
UHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end the adjustment
and return to the cursor mode.
ŏ 6HOHFW >&0%)/3 WR (/(@ DW WKH 0RGHO PHQX DQG
access the setup screen shown below by touching
the RTN button.
* T h e d i s p l a y s c r e e n i s a n
example. The actual screen
depends on the model type.
Scrolling
ŏ0RYLQJ FXUVRU
ŏ6HOHFWLQJ PRGH
ŏ$GMXVWLQJ YDOXH
ŏ7R QH[W SDJH
*OLGHU&XUUHQWO\VHOHFWHGFRQGLWLRQQDPH