Futaba 8FG 2.4GHz - Manual (Page 61)

61 )XQFWLRQVRI/LQNDJH0HQX!
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Linkage
menu by touching the
RTN button.
(1'32,17 Sets the travel and limit point of each servo.
7KH(QG3RLQWIXQFWLRQDGMXVWVWKHOHIWDQGULJKW
VHUYR WKURZV JHQHUDWHV GLIIHUHQWLDO WKURZV DQG
ZLOOFRUUHFWLPSURSHUOLQNDJHVHWWLQJV
7KHWUDYHOUDWHFDQEHYDULHGIURPWR
LQHDFKGLUHFWLRQRQFKDQQHOVWR$OVRWKHOLPLW
SRLQWZKHUHVHUYRWKURZVWRSVPD\EHYDULHGIURP
WR
6HUYRWUDYHODGMXVWPHQW
1. Move the cursor to the travel item of the
channel you want to adjust and touch the
RTN button to switch to the data input mode.
2. Ajust the rate by scrolling the touch sensor.
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
reset to the initial value.
Touch the RTN button to end adjustment and
return to the cursor mode.
3. Repeat this procedure for each rate.
/LPLWSRLQWDGMXVWPHQW
1. Move the cursor to the limit point item of the
channel you want to adjust and touch the
RTN button to switch to the data input mode.
2. Ajust the limit point by scrolling the touch
sensor.
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHOLPLW
point is reset to the initial value.
Touch the RTN button to end adjustment and
return to the cursor mode.
3. Repeat this procedure for each limit point.
ŏ 6HOHFW >(1' 32,17@ LQ WKH /LQNDJH PHQX DQG
access the setup screen shown below by touching
the RTN button.
7KHGLVSOD\VFUHHQLVDQH[DPSOH7KH
VFUHHQGHSHQGVRQWKHPRGHOW\SH
Scrolling
ŏ0RYLQJ FXUVRU
ŏ$GMXVWLQJ YDOXH
ŏ7R QH[W SDJH
(limit point)
(travel)
(limit point)
(travel)