Futaba 8FG 2.4GHz - Manual (Page 38)

38 0RGHO%DVLF6HWWLQJ3URFHGXUH!
7KURWWOH3LWFKFXUYHVHWWLQJ
7KLV IXQFWLRQ DGMXVWV WKH WKURWWOH RU SLWFK
operation curve in relation to the movement of the
throttle stick for each condition.
7KURWWOHFXUYHVHWWLQJH[DPSOH!
$FWLYDWHWKHWKURWWOHFXUYHRIHDFKFRQGLWLRQZLWK
WKHFRQGLWLRQVHOHFWVZLWFK
ŏ1RUPDO FXUYH DGMXVWPHQW
Normal curve creates a basic throttle curve
centered near hovering. This curve is adjusted
together with the pitch curve (Normal) so that the
engine speed is constant and up/down control is
easiest.
ŏ,GOH XS FXUYH DGMXVWPHQW
The low side Throttle curve creates a curve
matched for aerobatics (loop, roll, 3D, etc.).
ŏ7KURWWOH KROG FXUYH DGMXVWPHQW
The curve is not used when performing auto rotation
dives.
&RQÀUP WKDW WKH UDWH RI WKH VORZHVW SRVLWLRQ RI
WKH VWLFN LV LQLWLDO VHWWLQJ
<([DPSOHRISLWFKFXUYHVHWWLQJ!
$FWLYDWHWKHSLWFKFXUYHRIHDFKFRQGLWLRQZLWK
WKHFRQGLWLRQVHOHFWVZLWFK
ŏ3LWFK FXUYH 1RUPDO
Make the pitch at hovering approximately +5º~6º.
Set the pitch at hovering with the stick position at
WKH SRLQW DV WKH VWDQGDUG
*Stability at hovering may be connected to the throttle curve.
$GMXVWPHQWLVHDV\E\XVLQJWKHKRYHULQJWKURWWOHIXQFWLRQ
and hovering pitch function together.
ŏ3LWFK FXUYH ,GOH XS
The idle up 1 pitch curve function creates a curve
PDWFKHG WR DLUERUQH ÁLJKW
Set to -7º~+12º as standard.
ŏ3LWFK FXUYH ,GOH XS
The high side pitch setting is less than idle up 1.
The standard is +8º.
ŏ3LWFK FXUYH +ROG
At auto rotation, use the maximum pitch at both
the high and low sides.
[Pitch angle setting example]
Throttle hold: -7º~+12º
6HUYR&RQQHFWLRQ
&RQQHFW WKH WKURWWOH UXGGHU DLOHURQ HOHYDWRU
SLWFK DQG RWKHU VHUYRV LQ DFFRUGDQFH ZLWK WKH
kit instruction manual. For a description of the
FRQQHFWLRQ PHWKRG VHH 5HFHLYHU DQG 6HUYRV
Connection".
Note: The channel assigned to each function
can be checked at the Function menu of the
Linkage Menu.
ŏ ,I WKH GLUHFWLRQ RI RSHUDWLRQ RI WKH VHUYR
is incorrect, use the Reverse function of
the Linkage Menu. Also use the swash AFR
function in other than the H-1 mode.
ŏ $GMXVW WKH GLUHFWLRQ RI RSHUDWLRQ RI WKH J\UR
(Gyro side function)
ŏ &RQQHFW WKH WKURWWOH OLQNDJH VR WKDW WKH
carburetor can fully close at full trim throttle
cut.
ŏ $GMXVW WKH QHXWUDO SRVLWLRQ DW WKH OLQNDJH VLGH
DQG ÀQH WXQH ZLWK WKH 6XE7ULP IXQFWLRQ DQG
End Point function. To protect the linkage,
a limit position can also be set with the End
Point function.
ŏ 6ZDVK SODWH FRUUHFWLRQ ([FHSW + PRGH
,I DQ\ LQWHUDFWLRQV DUH QRWLFHG IRU D GHVFULSWLRQ RI WKH
OLQNDJH FRUUHFWLRQ IXQFWLRQ SOHDVH UHIHU WR WKH 6:$6+
IXQFWLRQS