Futaba 8FG 2.4GHz - Manual (Page 114)

114 )XQFWLRQVRI0RGHO0HQX+HOLFRSWHU)XQFWLRQV!
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
RTN button.
THR HOLD
This function sets the throttle cut position for
auto rotation. The throttle servo operating speed
FDQEHDGMXVWHG6SHHG
Note: Initially, this setting does not assign the
throttle hold switch. Prior to adjusting the
parameters for the throttle hold, we suggest
designating a throttle hold switch. To do so,
access the Condition menu within the Model
menu options.
ŏ6HUYR VSHHG
6HWWLQJPHWKRG
Ɣ+ROGFRQGLWLRQVZLWFKVHOHFWLRQ
Use the Condition select menu of the Model
menu to assign the hold condition switch.
Selection example: SG
Ɣ+ROGSRVLWLRQDGMXVWPHQW
Move the cursor to the hold position item
and touch the RTN button to switch to the
data input mode.
Adjust the rate by scrolling the touch sensor.
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
+ROGSRVLWLRQVHWVWKHWKURWWOHFXWSRVLWLRQ$GMXVWLWVRWKDW
the carburetor is completely closed.
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
UHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end the adjustment
and return to the cursor mode.
Ɣ6HUYRVSHHGVHWWLQJ
Move the cursor to the servo speed item and
touch the RTN button to switch to the data
input mode.
Adjust the rate by scrolling the touch sensor.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
UHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to return to the cursor
mode.
ŏ 6HOHFW >7+5 +2/'@ DW WKH 0RGHO PHQX
and access the setup screen shown
below by touching the RTN button.
Scrolling
ŏ0RYLQJ FXUVRU
ŏ6HOHFWLQJ PRGH
ŏ$GMXVWLQJ YDOXH
ŏ+ROG SRVLWLRQ VHWWLQJ
ŏ+ROG SRVLWLRQ
ŏ&XUUHQW SRVLWLRQ
2SHUDWLRQSUHFDXWLRQV
:DUQLQJ
:KHQDFWXDOO\VWDUWLQJWKHHQJLQHDQGIO\LQJ
DOZD\VVHWWKHLGOHXSFRQGLWLRQVZLWFKWR2))
and start the engine at idle.