Futaba 4PL 2.4GHz FHSS - Manual (Page 97)

97
Fu
n
c
tio
n
Adjuster "ADJUSTER"
(Preparation)
-On the system menu screen, select the ADJUSTER screen
by selecting "*ADJUSTER" with the (UP) or (DN) button and
pressing the (CT) button.
- If "WHEEL" (steering side) is selected by (UP) or (DN) but-
ton, the adjuster screen is displayed by pressing the (CT)
button.
1
(Steering neutral adjustment)
In the neutral setup screen state (figure at the right), lightly
turn the steering wheel to the left and right, then press the (+)
and (-) buttons simultaneously in the state in which the wheel
is not being touched.
2
(Steering throw adjustment)
In the throw setup screen state (figure at the right), lightly
turn the wheel fully to the left or right and when PUSH +/- is
displayed, press the (+) and (-) buttons simultaneously.
Internal check is performed automatically. When each adjust-
ment point is within a fixed range, correction is performed
and "COMPLETE" (figure at the right) is displayed.
If an adjustment point is not within a fixed range, correction
is not performed and the correction data is not updated.
When the correction data is not updated even though cor-
rection was performed again, please contact a Futaba Radio
Control Customer Center.
Steering adjustment
Adjuster "ADJUSTER"
Steering wheel and throttle trigger neutral position and servo operating angle correction
can be applied. This is used when a mechanical offset has occurred for some reason.
*However, when correction was applied, the set value of all the setting functions
must be rechecked.
Display the adjuster screen from the system menu.
Throttle trigger
Steering wheel
CT
(SYSTEM menu screen) (ADJUSTER screen)