Flintec MCS-64 ModbusOnEthernet - Manual (Page 14)

Page 14 Manual MSC-64: Modbus on Ethernet
Part B
5 COMMANDS
These pages describe the ASCII commands as they must be used by the DOP software. For
each command the corresponding Modbus register and data types are shown in brackets [ ]
for reference.
5.1 System diagnosis – ID, IV, IS ......................................................................................15
5.2 Calibration Commands – CE, CM, CI, DS, DP, CZ, CG AZ, AG, ZT, FD, CS.............16
5.3 Motion detection Commands – NR, NT.......................................................................20
5.4 Filter setting Commands – FM, FL, UR .......................................................................21
5.5 Set Zero/Tare and Reset Zero/Tare Commands – SZ, RZ, ST, RT ............................23
5.6 Output Commands – GG, GN, GT, GS .......................................................................25
5.7 Setpoint Commands - Sn, Hn, An ...............................................................................26
5.8 Trigger Commands – SD, MT, GA, TE, TR, TL...........................................................28
5.9 Trigger Special Commands– RW, TT, TS, DT, TW, TI, HT.........................................31
5.10 Save calibration, setup and setpoint parameters Commands – CS, WP, SS .............34
5.11 Filling Commands – PD1 to PD21, DI, SC, AC, GD, DT, SD ......................................35
5.12 Loss in Weight Commands – PL1 to PL5, LC, LI, GF, GR, GM, SL...........................35
5.13 Speed Estimation Multi-Channel System MCS-64 ......................................................35