FingerTec AdapTec-X - Manual (Page 11)

11
WALL
4 feet / 1.2 meter
(recommended)
1
Screws
Back Steel
Plate
2
3
UNDERSTANDING ADAPTEC-X INSTALLATION FOR
•
Wooden Door or Glass Door
The diagrams below only highlights the use of an EM lock during installation.
You may opt to use a dropbolt/deadbolt/door strike instead. Please consult a
qualifi ed technician/installer before proceeding with the installation.
1
To install FingerTec AC900/R2 on a wall, drill 5 holes as shown. 4 small holes
are for the screws and the bigger hole is for the network cable.
2
Tighten the 4 screws to fix the
Back Steel Plate on the wall.
3
Install the keyswitch as per instructions given in the box. The keyswitch is an
override key in case of a system failure or breakdown.