FingerTec R3 Manual - Manual (Page 3)

Screwdriver
Use the screwdriver to open
the back plate of fingerprint
terminal and to install the
back plate against a wall.
A Packet of Bolts
Use the screws to hold the back
plate of the terminal against a wall.
RFID Cards (5 pieces)
For card enrollment and
verification.
TCP/IP Connector
Connect the network cable from
a PC or Network switch to a TCP/
IP connector at the terminal.
Door Accessories Cable
Cables for 1V door lock, push
button, 1V alarm, door sensor and
1V door bell, for door access.
RS/RS485/Wiegand Output
Cable
For serial cable connection and
Wiegand output connection.
Power Connector
To connect the terminal to a
1V power supply.
Diode
A diode allows electricity to flow in
one direction only and blocks the
flow in the opposite direction. This
is known as a one-way valve on EM
Lock power for protection.
1• GETTING STARTED
Viewing the User Guide in the Internet
The User Guide is available in the package when you purchased the terminal. The User
Guide is also available online at:
http://www.fingertec.com & http://user.fingertec.com
Choose the language that you prefer for your User Guide.
Terminal Included Accessories
Do not abuse the fingerprint sensor by scratching the surface, contacting the sen-
sor’s surface with heat, pressing hard during placement of fingerprint for verifica-
tion. Clean the sensor occasionally with microfiber cloth to maintain the perform-
ance of the sensor.