FingerTec H2i Manual - Manual (Page 22)

22 CONTENTS
inserted for example user ID 12345” > “Deletion is successful. Delete User. Please
input user number” > Repeat to insert user ID to delete > (undetermined steps ) >
“The system returns to verification mode”
To delete all users including the user for an administrator card: Plug keyboard to
terminal > The LED of keyboard lit up > Insert keyboard password > “Password
confirmation is successful” > Press button 9 > Press ENTER > Press button 9 > Press
ENTER >
“Delete All Users. The operation is successful. The system returns to
verification stage. Please register the administrator card”.
After the operation, the H2i will be completely empty. You must re-enroll adminis-
trator card into the terminal to start over.
Confi guring IP address, Subnet Mask and Gateway
by using USB numeric keypad
In case you are going to install multiple H2i in an environment, setting up IP ad-
dress to every H2i becomes troublesome. Now you may consider using the USB
numeric keypad to ease the job.
Plug keyboard to the terminal > The LED of keyboard lit up > The Green LED blinks
> Insert password via keyboard >
“Password confirmation is successful” > Press
button 4 > Press ENTER > “Please enter the IP address” > Insert IP address using
keyboard, example 198.168.1.2 > Press ENTER> “key operation is successful >
“Please enter the Subnet Mask” > Insert Subnet mask using keyboard, example
255.255.255.0 > Press ENTER > * “key operation is successful > “Please enter the
Gateway” > Insert Gateway using keyboard, example 192.168.1.1 > Press ENTER >
“key operation is successful” > “Please enter the Device ID > Insert Device ID
using keyboard, example 2 > Press ENTER > “key operation is successful” >
“System returns to verification mode”
Restoring The Terminal to Default Factory Setting
Plug keyboard to terminal> The LED of keyboard lit up > insert keyboard password
>
“Password confirmation is successful” > Press button 3 > Press ENTER > Press
button 3 > Press ENTER > “Restore to default settings. The operation is success-
ful” > The system returns to verification mode.