FingerTec H2i Manual - Manual (Page 16)

16 CONTENTS
Once done, a popup window will appear indicating the update is successful. Click OK
to proceed. The Ingress software has to be synced with all relevant devices in order
for the changes to take effect. A small window will appear at the bottom left corner of
the screen once any changes are made.
Click on the underlined blue sentence to sync the terminals. Any changes made will
appear in the
Synchronize Device Settings window. Check/Tick the changes needed
to be synced to the terminals. Click Start Synchronize once the selections are made.
Another popup window will appear, displaying the changes made at the particular
doors affected. Click
Start Synchronize once everything is confirmed.
Once synchronization is complete, click Close to proceed. Go to Other tab and click on
Reboot Device . A window will pop up, seeking confirmation on whether to restart the
device. Click Yes and the IP address for the terminal has been successfully changed.