L i i 1 u i – Toshiba TEC MA-1100-400 SERIES User Manual
Page 77
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADDRESS NO.
11
CONTENTS
SELECTIVE ITEMIZER CONTROL
BIT
NO.
ITEM
SELECTIVE STATUS
STANDARD
STATUS
REMARKS
1
D
SI/TL Print
RESET
—on Receipt and Remote Slip
-(but prints on Journal only)
SET
NON-PRINT
* _
2
®SI/TL Compulsory
Before Finalizing
each Sale
RESET
FREE
*
SET
COMPULSORY
3
B
SI/TL
%-
Affect
Main Itemizer
RESET
IGNORE
*
SET
AFFECT
4
0
SI/TL %+ Affect
Main Itemizer
RESET
IGNORE
*
SET
AFFECT
6
—vacant—
RESET
SET
6
—vacant—
RESET
SET
7
—vacant—
RESET
SET
8
—vacant—
RESET
SET
Standard Bit Set
L I I 1 U I
№TES Q: When either Bit No.3 or No.4 is selected to the "SET" status, the S.I. total amount will
be printed on receipt regardless of the Bit No.l status selection.
R: If status "SET" (COMPULSORY) is selected, depression of the 1^1/TL1 key is compulsory
before finalizing a sale that contains any item with the S.I. status. Otherwise, it will
result in an error,
B £ 0:
If, for example,
b%
has been preset for the Sl/TL
%
and the "SET" (AFFECT) is selected
for Bit No.3, the amount calculated out as 5^ of the S.I. total amount will auto
matically be printed and subtracted from the main itemizer.
* Status Selection Combinations;
Bit No,3 ... RESET —j_rSI/TL operation will not affect the main itemizer
RESET -T at all.
SET —|j-Will result in the same condition as only the "SET"
SET —• status of Bit No.4 is selected (i.e., AFFECT by preset
X+
rate.)
Bit No,4
Bit No.3
Bit No.4
* If no preset
%
rate is programmed but either of Bit No.3 or No.4 is set to "SET"
(
affect
) status, the calculation will result on the basis of the rate of 100%.
- 73 -