Tax table programming – Toshiba TEC MA-1100-400 SERIES User Manual
Page 107
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONDITION:
After Auto Reset and GT Reset
OPERATION: Mode Lock: SET
TAX TABLE PROGRAMMING
1) Tax 1 Full Breaks
max. amount non-taxable
I max, amount for
Ifii
tax levied | 1
TXl/M 1
[max, amount for 2^ tax levied|
-*•
I
TXl/Mi
Repeat until the "A" Break is enterd.
I max, amount for N^ tax levied 1 ITXl/M1 ... "A" Break
I ST I (to indicate the "A" Break entry)
I max, amount for N+l);( tax levied] fTXl/Ml
I max, amount for N+2)z( tax levied 1 -> 1 TX17
m
I
Repeat until the "B" Break is entered.
IAT/TLI (to end)
NOTE: The amount entry may be a maximum of 4-digit value
(9999fi^) *
2)
Tax 1 "A” Break and
%
Rate Combination
First set the "A” Break following the same operation up to the "A"
Break entry and the 1ST I depression in the above "1) Tax 1 Full
Breaks".
i
I TAX RATE applied when exceeding the "A" Break amount]
(Maximum 5 digits, up to 99-999^- Use the Q key to enter decimal
portion, if any. Example: To set
5%,
enter 5* To set 5*003^,
enter 5
-
^
[
Z
I
■
The fraction of the amount resulting from this
%
rate calculation will be rounded off.)
+
lAT/TLl (to end)
3) Tax 1
%
Rate Only
|0l IW
m
I ^ [H] [TAX
rate
! -> ÎAT/TLl
(The conditions of the rate are the same as
the above TAX RATE.)
- 103 -