Cleaning the slip detector – Toshiba TEC MA-1100-400 SERIES User Manual

Page 136

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CLEANING THE SLIP DETECTOR

Cleaning the slip detector when replacing the receipt, journal, or ink ribbon.

If the slip detector has not been cleaned for long periods, the cash register

may fail to be registered on. In such a case, the "slip lamp” will be kept

on- This is the same state as when a slip is inserted because of paper dust

deposited on the slip detector.

How to Clean the Slip Detector

1. Turn off the

power switch.

(The power switch

is located on the

right side of the

Power Switch

Push

. Remove the ribbon

cover.

Ribbon Cover

The cover is unhooked

when slightly pushed

in the direction of

the arrow.

4. The slip detector is indicated by

the arrow.

, _ journal

Receipt

Ribbon

Dot Head

If the dot head is located on the right

side of the machine, close the cutter

cover and turn the power ON, and the

dot head will move and stop on the

left side.

5. Clean the slip detector with

a brush.

After cleaning, make sure that the

ink ribbon is properly mounted on

the ribbon guide.

Close the ''

"^7. Turn on the power switch. ''

^8. Depress ^

cutter cover.

NOTES:

the rNS"

(Securely

1. If the display is blinking

key to

hook the

it indicates that the

issue a

cover on the

cutter cover is not pro-

receipt.

left side.)

perly closed. Securely

Check that

close the cover.

the

2. Depress the key.

receipt is

The display should turn

printed

lit.

normally.

------------

_______________

9, Install the

ribbon

cover,