Toshiba TEC MA-1100-400 SERIES - Manual (Page 50)

TABLE OF OPERATIONS FOR X AND Z REPORTS — Continued —
REPORT NAME KEY OPERATION
PLU READ AND RESET
ZONE PLU READ
ZONE PLU RESET
ALL PLU READ
ALL PLU RESET
INDIV.PLU READ
Mode Lock: X
Mode Lock: Z
Start PLU Code
Mode Lock:
Mode Lock:
>[M]
I @/F0R|
End PLU CodeUrPLUl
Mode Lock: X only^ enter the required
PLU Code followed by j PLUI. This may
be repeated by alternating the code.
1st I may be used to obtain sub-total.
IAT/TLi to end.
DEPARTMENT READ AND RESET
INDIVIDUAL DEPARTMENT READ Mode Lock: X, Depress the required Dept
Keys, one by one,
I
ST
I
may be used to
obtain sutotal, 1AT/TLI to end.
ALL DEPARTMENT READ
ALL DEPARTMENT RESET
(available
-J only when the
"Auto Read/
Reset Report
Separated"
option is
selected)
> 11 ^ IAT/TL1
Mode Lock: X
Mode Lock: Z
(If the "Auto Read/Reset Report
Separated" option is not selected,
the Department data are printed on
Auto Read/Reset Report listed below)
HOURLY READ AND RESET
HOURLY READ
HOURLY RESET
Mode Lock: X
Mode Lock: Z
■> 10
I
AT/TL
I
CLERK READ AND RESET
INDIVIDUAL CLERK READ
INDIVIDUAL CLERK RESET
Mode Lock: X -*i-»Set the required Clerk
Mode Lock: Z Key to ON, enter 1,
depress 1AT/TL|.
AUTO READ AND RESET
(DEPARTMENT + FINAICIAL + CLERK)
AUTO READ
AUTO RESET
Mode Lock: X
Mode Lock: Z
GT READ AND RESET
GT READ
GT RESET
Mode Lock: any position
1 at / tl ]
GT Lock;
GT Lock:
GTX
GTZ
NOTES: 1. The drawer will open on the depression of the final key of the
KEY OPERATION for the reports marked with "-5''" in the above table.
2. The drawer will open also for the reports marked with on
the depression of the final
I
AT/TL
I
key. However,
it
will not
open if so programmed in the system option.
3. No Clerk Key is necessary to issue reports except CLERK READ AND
RESET.
4* Refer to the report samples on the following pages. as for the
PRESET DATA VERIFICATION, which is available in the "X" mode,
see the "VERIFICATION OF PROGRAMMED DATA" near the end of this
manual.
- 46 -