Toshiba TEC MA-1100-400 SERIES - Manual (Page 132)

When the receipt and journal print is too
light, replace the ink ribbon in the
following manner.
Removing the Ribbon
1. Turn the Power Switch to OFF.
2. Remove the Ribbon Cover. Press the side
inward and the hook will unlocked (Fig.14).
3. Open the Cutter Block by pulling it upward
while pressing the leftside lever outward,
(Fig. 15 and Fig. 16)
4. Remove the Ink Ribbon by lifting up the
ribbon spools (Fig. 17).
Installing the Ribbon
1. Set the ribbon spools so that the ribbon
will be wound to the directions shown by
the arrows respectively. Meanwhile, let
the ribbon go through the Ribbon Guides,
the Tension, arid the Dot Head Ribbon Guide
(Fig.18 and Fig.19).
2. After setting, make sure that the ribbon
properly goes through each required parts
by turning a ribbon spool several turns.
3. Close the Cutter Block. Make sure that
the leftside lever has locked the block.
4. Turn the Power Switch to ON.
5. Depress key. The flashing display
will stop and be lit steadily.
6. Attach the Ribbon Cover.
REPLACING THE INK RIBBON
R i b b o n
Fig, 18
•I'OQ _