Toshiba TEC MA-1100-400 SERIES - Manual (Page 70)

ADDRESS NO. CONTENTS
VALIDATION COMPULSORY I
BIT
NO.
ITEM SELECTIVE STATUS
STANDARD
STATUS
REMARKS
1 IRTN MDSEI Kev
RESET FREE *
SET COMPULSORY
2 IPQI Key
RESET FREE *
SET COMPULSORY
3 117TI Key
RESET FREE *
SET
COMPULSORY
A
B
lITEM CORRI Kev
RESET
FREE *
SET
COMPULSORY
5
B
RESET
FREE *
IVOIDl Key
SET
COMPULSORY
6
New Balance in
Post Charging RESET FREE *
SET
COMPULSORY
7 —vacant—
RESET
SET
8 —vacant—
RESET
SET
Standard Bit Set
NOTE: If status "COMPULSORY" is selected, the "SLIP" lamp will flash after operating the key,
and thereafter no other operation except validation printing will be allowed. This status
will be effective in the "REG" and ' "MGR" modes only. In the " Q" mode, , validation print"
ing may be performed freely (not compulsory) after any function key reg ardi ess of the
FEE/COMPULSORY status selected for each key in the above table.
D: The selection of Bit No.A will also be applied to the IIC/VD! key when it is used as the
ITEM CORRECT key.
The selection of Bit No.5 will also be applied to the IIC/VOI key when it is used as the
VOID key.
- 66 -