Toshiba TEC MA-1100-400 SERIES - Manual (Page 130)

PAPER ROLL REPLACEMENT AND OTHER MAINTENANCE OPERATIONS
P a p e r E n d
INSTALLING THE RECEIPT PAPER
1. Turn the Mode Lock to the "REG" position.
2. Remove the Receipt Cover by pulling it
upward (Fig. 1).
3. Set the new paper roll in the receipt roll
holder with the paper end fed from the
bottom as shown in Fig. 2 (Fig. 3).
4. Insert the paper end into receipt inlet as
holding the | RF~] key pushed down (Fig. 4).
5. When the paper comes out of the receipt
outlet for approx. 5cm (or 2 inches),
release the IRFI key (Fig. 5).
6. Attach the Receipt Cover. Meanwhile, the
paper end must be seen outside the cover.
7. Press the key to clear the paper-end
condition, and depress the | NS | key and
cut the issued . receipt to check if the
paper has properly set.
REMOVING THE RECEIPT PAPER
1. Remove the Receipt Cover by pulling it
upward (Fig. 1).
2. Pull the Free Lever frontward while pull­
ing the old paper core upward to remove
the remaining receipt paper tail (Fig. 6).
- 126 -