JVC MX-J680V - Manual (Page 19)

Continued
To locate a particular point in a track
During play, press and hold ◄◄ or
I: Fast reverses the disc.
►: Fast forwards the disc.
When using the remote control, press and
hold ◄◄ / or ►►1 /1
To go to another track
Press or repeatedly before or during
playback.
<: Goes back to the beginning of the
current or previous tracks.
H: Skips to the beginning of the next or
succeeding tracks.
When using the remote control, press ◄◄ /
or
(or or /notes I Vyou press and hold K^/
before playing)
You can change the trades continuously.
On the remote control:
To go to another track directly using the number
buttons
Pressing the number button(s) before or
during play allows you to start playing the
track number you want.
Ex.: For track number 5, press 5.
For track number 15, press +10, then^^
5.
For track number 20, press +10, then
10 .
For track number 32, press +10 , +10, +10, then 2.
Programming the Playing Order of the Tracks
— Program Play________________________
You can program the order in which the tracks play before
you start playing. You can program up to 32 tracks.
• To use Repeat play (see page 15) for Program play, press
REPEAT after starting Program play.
1
Load the CDs.
• If the current playing source is not the CD player, press
CD ►/!!, then ■ cJk before going to the next
step.
PROGRAM
/RANDOM
2
Press PROGRAM/RANDOM
repeatedly until “PROGRAM”
appears on the display.
O O n r O Q bd
/ I ^ U U I ^ n I I
If a program has been stored in memory, the program is
called up.
Each time you press the button, CD play mode changes
as follows:
c Program Play-
---------- Continuous Play
Random Play
□
3
Press one of the disc number
buttons (CDl, CD2, and CD3) to
select the disc number you want to
play.
^
Track number
-i-
? ,p
Disc number Program step number
4
Select a track from the CD selected in the
above step.
On the unit:
Press or to select the track number,
then press SET.
On the remote control:
Press the number buttons.
• For how to use the number buttons,
see “To go to another track directly
using the number buttons” described
to the left.
O „
L
I 7J
I _/
P
5
Program other tracks you want.
• To program tracks from the same disc, repeat step 4.
• To program tracks from a different disc, repeat steps 3
and 4.
6
Press CD ►/!!.
The tracks are played in the order you have programmed.
To stop during play, press ■ cJi.
To exit from Program play mode, press PROGRAM/
RANDOM repeatedly again before or after play so that the
unit enters another play mode. (The program you have made
is stored in memory until you turn off the unit for a few days
or erase the program.)
- 1 4 -