Receipt and journal paper end detection, When a power failure occurs, Hardware options available – Toshiba MA-290-100 SERIES User Manual
Page 82: Flu keyboard, Remote slip printer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECEIPT AND JOURNAL PAPER END DETECTION
When the Receipt or Journal roll comes to the end, the detector autoamtically
functions to inform the paper-end condition, by flickering the amount portion
display (it also flickers when either paper roll is not set properly). In
this condition, no other keys except [RF] and [JF] will be accepted.
In this case, replace the paper roll referring to the descriptions on pages
74
and
75.
When the paper setting is completed, depress the
[c]
key on the
keyboard. Now operations will be accepted. If a printout has been stopped
halfway, it will also be continued. The [C] key will not be accepted before
setting the paper.
WHEN A POWER FAILURE OCCURS ...
When the power is restored from a power failure, the register will display the
last item entered before the power failure if the item was entered through a
motorized key (such as [DEPT], media keys, etc,). In this case, continue the
registering operation. However, if the register displays "FAIL" when the
power is restored, it indicates that the last item entry was not completed
(i.e., only numeric keys or a declaration key such as [RTN MDSE] were operated
but no any motorized key). In this case, first depress the [C] key to clear
the "FAIL" condition, and then do the registering operation again from the
numeric or declaration key entry. In the event of a power failure, please be
sure to check the receipt before it is handed to the customer.
HARDWARE OPTIONS AVAILABLE
The following hardware devices are available as options.
FLU KEYBOARD
It has 130 keys, each of which corresponds to a PLU code. By simply
depressing a key, the "|PLU Code|-»[PLU]" entry sequence is made. Thus
it simplifies PLU operations and saves time. The PLU Keyboard will be
connected to the ECR with a one-meter cable and may be placed on the
check-out counter table near the ECR.
REMOTE SLIP PRINTER
By connecting it, required transactions will be recorded on the remote
slip as well as on the receipt and the journal rolls.
^ 73 -