Toshiba MA-290-100 SERIES - Manual (Page 7)

GT LOCK
(^6TZ
This lock is provided to read or reset the accumulated
sales totals not on the daily but on weekly or monthly
basis.
GTX Position:
This position allows to read the
accumulated totals.
The GTX Key as well as GTZ Key can access
this position.
GTZ Position:
This position allows to read and reset the
accumulated totals.
The GTZ Key only can access this position.
NOTE: When the GT Lock is turned to either the
GTX or GTZ position, the Mode Lock position
will be disregarded.
CLERK LOCKS
Lock-and-Key Type (Standard) These locks are used to identify which
clerk is operating the register.
1 2
3 . 4
Clerk Keys (CLl, CL2, CL3, CL4)
Each clerk should keep his/her clerk key. The
register will not operate in the "REG", "MGR", or
" Q *' unless one of these keys is inserted and
set to the corresponding position on the Clerk Locks.
Each of the keys may be inserted and pulled out in the
neutral position marked with the (point).
Push-key Type (Alternative Option, for ten clerks)
1 2 3 4 5
6 7 8 9 10
This type may be installed in place of
the Clerk Locks above, as an
alternative option. In that case, ten
clerk keys will be installed. Each
clerk is assigned to his/her own clerk
key (1 through 10). The register will
not operate unless one of these keys
is pushed to stay down, just as the
Lock-and-Key Type Clerk Keys.