Toshiba MA-290-100 SERIES - Manual (Page 80)

REPLACIHG THE INK ROLL
Cover
Fig. 4
When the receipt and journal print is
too light, replace the ink roll in the
following manner.
1. Turn the Power Switch to OFF.
2. Remove the cover located on the
lefthand side of the cabinet, by
lifting it up, as shown in Fig. 1.
3. Press down the lever, and withdraw
the Ink Roll (Fig. 2).
4. Insert a new Ink Roll into the hole,
push it all the way in, and push up
the lever (Fig. 3).
5. Attach the cover, by inserting the
top edge first and pressing the
bottom part next. (Fig.4)
NOTE: The Ink Roll is a consumable
product. Please order it to your
TEC representative when necessary.
REPLENISHING THE STORE NAME STAMP WITH
INK
When the store name stamp is printed too
lightly, replenish the ink in the
following manner.
1. Turn the Power Switch to OFF.
2. To remove the cover, follow Step 2
above.
3. Withdraw the store name stamp with
the protruding part pinched with your
fingers. (Fig.5)
4. Apply ink on the pad on the rear side
of the Store Name Stamp. The amount
of the refilling should be adjusted
according to the density of the
printed message, but the limit of 2
cc should not be exceeded. (The ink
bottle supplied contains 5 cc of
ink.) (Fig. 6)
5. Follow Step 5 above to attach the
cover, after setting the stamp to the
original position.
Store Name Starno
F i g . 6
- 76 -