Wi9.fi 4, T 3 9 . b h d – Kenwood TM-431E User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

4-5-4. Programmable Band Scan
1.
The lower scan limit should be stored into memory chan
nel 1 5, and the upper scan limit should be stored into
channel 16.
CAUTION:------------------------------------------------------------------------------------------------
If the frequency in memory channel 1 5 is equal to or higher
than
the
frequency
stored
in
channel
16
scan
will
proceed
over
the
entire
tuning
range
of
the
set,
i.e.
it
will
function
like the Band Scan previously described.
2. Adjust the SQL control to the squelch threshold point.
3. Press the VFO key to select the VFO mode.
4.
Select
a
frequency
between
the
two
programmed
scan
limits.
5.
Press the VFO key for longer than one second. The MHz
indicator will begin flashing as a visual reminder the tran
sceiver is scanning.
6.
Scan will begin in an upwards direction. You can change
the
direction
of
scan
by
turning
the
tuning control
or
by
pressing the microphone UP/DWN switches.
7.
Scan will stop whenever a signal is received that will open
the squelch of the radio.
8. Press the PTT switch or any front panel key to stop scan.
4-5-5. Memory Channel Scan
If
you
wish
to
scan
the
contents
of
the
memory
channels
use the following procedure:
1. Adjust the SQUELCH control to the threshold point.
2.
Press the MR key for longer than 1 second. The MHz in
dicator
will
begin
flashing
and
the
memory
channel
indi
cator
will
indicate
the
memory
channels
that
are
being
scanned.
26
3.
Scan will begin at the current memory channel and pro
ceed
upwards
thru
the
memory
channels.
You
can
change
the
direction
of
scan
by
turning
the
tuning
con
trol
or
by
pressing
the
microphone
UP/DWN
switches.
Only
those
memory
channels
that
have
data
entered
into
it will be scanned.
4.
Scan will stop whenever a signal is received that is capa
ble of opening squelch.
5.
To cancel scan press the PTT key or any other front panel
key.
S
For longer than 1 second
4-5-6. Memory Channel Lockout
This
function
allows
you
to
specify
which
memory
chan
nels
you
wish
to
scan
during
the
memory
channel
scan
function.
1. Press the MR key to select the Memory Channel Mode.
2.
Select the Memory Channel that you wish to skip by turn
ing
the
tuning
control
or
by
pressing
the
microphone
UP/DWN switches.
3.
Press the F key for longer
than 1 second. The F indi
cator will begin to flash.
Within
10
seconds
of
pressing
the
F
key
press
the MR key. A ★ will ap
pear
to
the
left
of
the
memory channel number.
This
indicates
the
Memory
channel
will
be
skipped
during
the
Memory
Chan
nel scan mode.
> t 3 9 . B H D
15
Flashing
Wi9.fi 4
'
Vrtiir-----------i — -5
-y-
-Q—
e
TT ----------------- :