T 7 s s .o a o, L г з 5 . 0 0 0 r ' b – Kenwood TM-431E User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

4-2-5. ALT (TM-531A/531E only)
The ALT system operates similar to an AFC (Automatic Fre
quency Control) system. This system is useful when the fre
quency
of
either
station
starts
to
drift.
When
this
occurs
distortion
of
the
signal
is
the
usual
result.
The
ALT
system
will detect the drift and shift the frequency to compensate.
To activate the ALT function
1. Press the F key momentar
ily. The F indicator will turn
on in the display.
l г з 5 . 0 0 0 r ' B
i~ H ~g~
f
-dgeg- -
(Example)
Frequency
Transmit
Frequency Receive Frequency
of the Distant Station
(
alt
System is
performed.
Frequency '
Transmit Frequency Receive Frequency
of the Distant Station
Note:-------------------------------------------------------------------------
The
frequency
display
will
not
actually
change,
even
though
the
receive
frequency
might
shift
in
order
to
properly
tune
the
incoming
signal.
When
the
ALT
system
is
operating
the
Direction
indicator
in
the
display
will
turn
on
to
signal
a
change
in
the
receiver
frequency.
The
direction
indicator
will
show
you
if
the
incoming
signal
was
higher
or
lower
than
the displayed frequency.
2. While the F indicator is on
press
the
DRS/ALT
key.
The
ALT
indicator
will
turn
on and the receiver will au
tomatically
center
itself
on
the incoming signal.
3.
To
release
the
ALT
func
tion
press
the
F
key
momentarily
and
then
the
DRS/ALT key.
DftS AL^
GD
t 7 s S .o a o
Turns on when the transmit
frequency of the distant sta
tion is higher than your receive
frequency.
t
l| AL T r>
Turns on when the transmit
frequency of the distant sta
tion is lower than your receive
frequency.
19