Kenwood 855 AV - Manual (Page 53)

Specifications
Integrated amplifier
(KA-896)
Power amp section
Power output in stereo operation:
100 watts per channel minimum '
RMS, both channels driven,'at 8
ohms, from 40 Hz to’20 kHz, with
no more'than 0.09%,total harmonic
distortion (FTC)
Power output in surround operation:
Left, center and right channels;
70 watts per channel, I kHz,
0.9% THD,8ohms ’ .
Surround channel: 20 watts + 20
watts, i kHz, 0.9 %THD, 8 ohms
Pre amp section
Frequency response; -
Line (CD,"Tape, Video): 20 Hz to
60 kHz, +0 dB, -3 dB
Phono: (RiAA): 20 Hz to 20 kHz
+0.5 dB
Signal-to-noise ratio (IHP %6):
Phono: 75 dB .
CD, Tape, Video: 95 dB .'
Maximum input level (Phono):
l20 mV, 0.5 %THD at I kHz
Input sensitivity/impedance;’
Phono:'3.5 mV/47,k-ohms
CD, Tape, Video:. 200 mV/47 k-ohms
Adaptor loop input .
200 mV/47 k-ohms’ ' . ’ u
Output level/impedance:
Tape record: 200 mV/1 k-ohm"
Adaptor loop out 200 mV/1 k-ohm ■
Tone controls;
Bass:^ +10 dB at 100 Hz
Treble; +10 dB at 10 kHz
Loudness control (volume at -30 dB):
+8dBat 100 HZ ^
General
Power consumption; 2.3 amps
Electrical outlet (2 switched);
400 watts max total
Dimensions:
Width: 17-5/.! 6"
Height 5-5/8"
Depth;l!-13/I6" .
Weight (net)r 205 lbs
Tuner (KT-596)
FM tuner section
Tuning frequency range:
87.5 MHz to 108 MHz
Usable sensitivity (IHP):
13.2 dBf ( 1.2 mv at 75 .ohms)
Total harmonic distortion (I kHz):
Stereo; 0.7 %
Mono: 0.6 % '
Signal-to-noise ratio at 65 dBf (IHF):
Stereo: 68 dB
Mono: 75 dB
Stereo séparation at I kHz (IHF):
40 dB
Capture ratio: 2.0 dB
Selectivity (IHF+400 kHz): 50 dB
Image rejection ratio (98 MHz):
50 dB
IF rejection ratio (98 MHz): 50 dB
AM supression ratio: 37 dB
Frequency response:
30 Hz to 15 kHz, 90.5 dB, -3.0 dB
Output level/impedance ( I kHz,
75kHz deviation): 0.6 V/3.3 k-ohm
AM tuner section
Tuning frequency range:
530 to 1700 kHz
Ueaable sensitivity:
l2mv/(500mV/m) '
53.