Kenwood 855 AV - Manual (Page 49)

Troublesho»
Sometimes things just don’t seem'to be working right
Dtillg
• Check that the speakers are turned ON. If the speak­
ers are ON, the SPEAKERS light is ON.
When this happens:
• First, look back over this manual to find the instruc- • Check that all your power cords are connected
tions for what you’re trying to do.. You may find the ■properly.
solution to your problem right there, . , '
• Check that the speaker cables are connected
• If that doesn't wor(<, look for the problem in this properly.
Troubleshooting guide. .
• Check that the input cable from the source compo­
• If you have a problem with another component nent is connected property.
check the manual for that unit
• Check*that the shorting plugs have not been removed
• If you still can't soJve the problem, call the store............... from the ADAPTER loop jacks.
where your purchased your system, or call a
Kenwood Authorized Service Center./ No sound from one of the speakers
• Check that the balance between the left and right
speakers isn’t settoa far.to one side.
Integrated Amplifier
• Check that the audio and speaker cables are
connected- properly.
The remote doesn’t work No sound from the surround speaker(s) and/or
• Check the batteries, and replace them if needed. center speaker, or the sound is abnormally low
• Checkthat one .of the surround modes is ON.
• Check that the remote is .close enough to the system:
that the controlling angle is small enough; that there's , • Checkthat the center speaker isn't set to
no obstacle in between'. . . PHANTOM.
• Check that you've placed your CD, videotape, laser • Check that the speaker cables are connected
disc, or other source in the proper player. properly.
• If you’re recording a tape, wait until the recording is • Check that the center speaker input cable is
completed.- -. ■. * . . - connected properly to the power amplifier center
input jack
• Check to make sure that the audio cables and .system .
control cables are connected properly. • Check that the CENTER and SURROUND speakers
are calibrated properly.
No sound from the system
• Check that the.volume is set at a proper level. Sound only from the center speaker when
Dolby Pro Logic is selected
• Check that the mute is OFF. ’ . / • Check that the program is recorded in stereo (mono -
programs will only play through the center speaker in
49.