Cd player, Tuner – Kenwood 855 AV User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/670582/50/background.png)
the Dolby Pro Logic mode). _
because the power cord was unplugged a long time. If
so, preset the station again." .
No sound from the subwoofer
• Check that the subwoofer’s power cord is properly
Interference with reception
pluggedJnto a wall outlet.:
• Check for interference from: electrical appliances. If so,
turn them OFF,
• Check that the audio cable is connected properly.
• Check for interference from the TV set. if so, turn it
• Check that the subwoofer volume control is not k
OFF, or move the antenna away from the TV.
turned all the wa/ down. —
• Checkfor interference, from automobiles. If so, install
The STANDBY light blinks, but there is no
sound
the outdoor antenna away from roads.
• Check that the speaker cables aren’t short-circuited—
None of the functions operate, or the display
that is', the (+) and (-) wires aren’t touching each
shows wrong information
other. If they are, separate the wires. . _ :
• Reset your unit’s microcomputer by unplugging the
power cord from the electrical outlet and plugging it
A hum when you select the PHONO input
• Check that the audio cables, are plugged securely into
back in while holding down the MEMORY button.
the PHONO jacks. ^ ‘ ' k
• Check that the turntable Js grounded on the rear
CD player
panel. The ground wire should be connected to the
screw labeled GND. _ . . T.. _.
Power light doesn’t come on
None of the functions operate, or the display
• Check that the power cord is properly plugged into
shows wrong information
the. electrical outlet on the back of the power ampli
• Reset your.unit's. microcomputer by unplugging the
fier. ,
power cord from the electrical outlet and plugging it
back in while holding down the POWER button. _ . ,
Player doesn’t play a loaded CD
• Check that the CD is loaded right-side up.
• Checkthat the CD isn't cracked or dirty.
Tuner
• There may be condensatioruDn the lens. Leave the ,
player on for at least I hour before using it
You can’t receive radio stations
• Check that the station is tuned in properly.
No sound
• Check that the CD is loaded properly.
• Checkthat the TUNER input is selected.
• Check that the CD isn't cracked or dirty.
• Check that the_antenna is connected properly.
• Checkthat the PLAY mode is active (the
You can’t receive a preset station by pressing
the corresponding number buttons
PLAY/PAUSE light should be ON),
• Checkthat the TUNER input is selected.
• Checkthat the audio cables are connected properly.
• Check that the preset station is a receivable
Skipping (mis-tracking)
frequency.
• Check that the CD isn’t cracked or dirty.,
• Check that the preset memory hasn't been cleared
• Make sure that the player isn’t subjected to strong
50.