Kenwood 855 AV - Manual (Page 37)

Listening to tapes
Playing a single tape
Before starting, be sure that the TIMER switch.is OFF.
1 Insert a tape into a cassette well. The tape type
(Normal or Chrome) is automatically selected.. .
2 Set the play mode.
ci) plays both sides of the .tape repeatedly.
> ) stops after playing both sides of the.tape.
___ stops after playing I side of the tape. -
3 Set the Dolby Noise Reduction mode, by moving the
switch to the proper setting for the tape .you’re
playing. For example, If your playing a .tape recorded
using Dolby C, select Dolby C.
4 If you're using the remote, press the AUDIO button
on the remote until the remote's display shows TAP
A or TAP B (depending on which, you're listening to).
5 On either the remote or the cassette deck’s front
panel, press the ◄ or ► button (depending on .which
side of the tape you want to listen to) to begin play.
6 Pr^ess the ■ button on either the remote or.the.
cassette deck’s front panel to stop play.
About the direction indicators:
The ◄ and ► indicators show the direction the tape is .
moving. If you turn the power OFF, the tape plays in the
same direction when you turn the power back ON.
37.