Checking the tracks you’ve selected, Clearing tracks from the selection – Kenwood 855 AV User Manual

Page 45

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

5 Press the EDIT MODE button again...................

6 Select the CD you want to tape using the DISC

SELECTOR buttons. -

■ -

7 Select the. tracks to tape using the TRACK SKIP

buttons.

■■

If you make a mistake, press the CLEAR button, and

select the correct track . ■

8 Press the P.MODE button after each track selection. '

The display shows the time remaining on Side-A!

If the time remaining on Side-A is shorter than the

track you selected, that track is programmed onto

Side-B. When B-FULL is displayed, both sides are full,

9 To tape from more than I CD, repeat steps 6

through 8. ,

to To tape, press the-CCRS.button on the cassette deck

Recording begins after about I minute. For an expla

nation .of CCRS, see page 42.

Checking the tracks you’ve selected

For a single CD, press the CHECK button. The track

numbers of the selected tracks are automatically

displayed.

For multiple CDs, press the,CHECK button. Each time

you press the button, you advance the display to the

next track number.

Clearing tracks from the selection

For a single CD, press the P.MODE or the

OPEN/CLOSE button.

For multiple CDs, press the P.MODE button,

.ill

i. ~l

45.