Sharp AQUOS LC-37GP1U - Manual (Page 35)

Useful adjustment settings
nidi ^.adjyst^^^
' ' fripytttdd6^:Gnlyi;:i;.:;
ffor;.^;na!p;g^;;
F-:ii' ;iiiU;niali;;ally arljuKling ilii-; P(' ini.'ig;-;.
I
I
Press MENU to display the MENU screen, and
then press -4/^ to select “Setup”.
Press A/T to select “Auto Sync.”, and then
press
ENTER
Press to select “Yes”, and then press
ENTER.
• Auto Sync, starts and “Now adjusting the image.”
dispiays.
- t MENU to exit.
When Auto Sync, is successful, “Compieted” dispiays. if
not. Auto Sync, failed.
Auto Sync, may fail even if “Completed” displays.
Auto Sync, may fail if the computer image has low
resolution, has unclear (black) edges, or is moved while
executing Auto Sync.
Be sure to connect the PC to the TV and switch it on
before starting Auto Sync.
It is not necessary to use “Auto Sync.” when a digital signal
is being input, so it cannot be selected.
f^irierSyycviadjdstpiipri^ j (fpri'D^rt
i;npyt:.mPcj;ehojrii.y|hY ...................................
Orriiii.irily you cvin oa.sily ariju.st 11 vm picduro ac
necessary to change image position using Auto Sync,
in some cases, however, manual adjustment is needed
to optimize the image.
Press MENU to display the MENU screen, and
then press - 4 /^ to select “Setup”.
Press to select “Fine Sync,”, and then
press
ENTER.
Press a /T to select the specific adjustment
■■■" item.
.... !..g!.....
, 1 1 , ,
H-Pos.
V-Pos.
Clock
Phase
P^bcriptiph
Centers the image by moving it to the .
or right.
Centers the image by moving it up or
down.
Adjust when the image flickers with vertical
stripes.
Adjust when characters have low contrast
or when the image flickers.
^ l-'h s - 4 /^ to adjust the item to your desired
position.
Press MENU to exit.
» For resetting aii Fine Sync, adjustment items to the factory
preset values, press to select “Reset", and then
press
ENTER.
• It is not necessary to adjust the “Clock” or “Phase" when a
digital signal is being Input, so it cannot be selected.
®- 34