Function, Command, F. setting the tad security code – Brother FAX-175 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

23
FUNCTION
COMMAND
DESCRIPTION
Play back message/memo #10
All messages
• Pressing * while message/memo is playing will bring you forward to the foilwing
message/memo.
Erase message/memo
#20
All messages
# 2 1
First message
#22
Second message
#23
Third message
You may continue this until #28 if the Number of ICM is set at eight (8) 14-second
messages.
Record message/memo
Record/Change
OGM
Playback OGM
FAX message count
Voice message count
TAD OFF
TAD ON
NOT USED
#30
#
#
#50
#60
#70
# 7 1
#
8
0
&
# 8
1
Record new message at once
Maximum of 255 messages are counted. The
counter is cleared each time the unit is set to
TAD.
Counts the number of ICM in TAD.
Turns the TAD off.
Turns TAD on.
Terminate Remote Control #90
Terminates the operation. If you do not
order this termination, the unit will cut
the connection automatically in 30
seconds unless you issue another
command.
NOTE: A short beep is heard repeatedly for 30 seconds when each function has been
completed. To continue with another function, press # within 30 seconds after a 1 sec. beep.
The FAX MESSAGE COUNT is a feature that is unique to Brother. Its main purpose is to save
you a trip to check on the arrival of that important fax message you've been waiting for. If the
count is zero, there is no need to rush back.
F.
Setting the TAD security code
The TAD security code is a three digit number that is designed to prevent unauthorized remote
access to the messages recorded on your TAD. The factory setting is 000. To set your own
code, follow this procedure:
1.
Turn the power OFF.
"CAUTION: BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE
EVENT OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNITS MAIN POWER
SWITCH."
2.
Press the HOOK button and keep it depressed until FINE lamp blinks as you turn the
power back ON.
3.
Press the FINE/PHOTO button four (4) times to select the TAD Security Code Set
Mode.