Ii. reception of documents, A. manual reception, B. automatic reception – Brother FAX-175 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Do not transmit documents that are too thin (tissue paper, tracing paper, etc.) The
thinnest paper suitabie for transmission is 0.055mm. Make a photocopy and transmit it
instead.
Remove all staples and paper clips from the documents to be transmitted.
Do not transmit documents held together by scotch tape. Photocopy them and
transmit the photocopy.
Do not transmit carbon papers. Make a photocopy and transmit it instead.
Do not transmit documents with siippery surfaces. Make a photocopy and transmit it.
II.
RECEPTION OF DOCUMENTS
The FAX-175 can receive manuaily or automaticaiiy. The choice is made by using the switch
marked AUTO ANS (lower front end of the unit). The OFF position switches the unit to manual
reception and the ON position aiiows automatic reception.
A.
Manual Reception
When the AUTO ANS switch is in the OFF position, the foilowing should be done when the
phone rings:
1.
Lift the handset.
2.
If you hear a series of fax beeps, you'il know that a fax message is coming in.
3.
Press the START/COPY button. The START/COPY iamp will iight up. As the
reception gets underway, the lamp will stay on. You may replace the handset in its
cradie. The paper wiil start coming out of the siot.
4.
When the reception is compieted, the unit wiil emit a long beep.
5.
Cut the recording paper with the received image. Make sure to do so oniy after the
iong beep so as not to affect the quaiity of the received image.
B.
Automatic Reception
When the AUTO ANS switch is in the ON position, the foliowing wili occur:
1.
The unit wiii receive the fax message automaticaiiy after one (1) ring. If you wish the
unit to receive the fax message after six (6) rings, use the switch on the back of the
controi panel (NO OF RINGS switch) to affect this change.
2.
The START/COPY iamp wiil light up. As the reception gets underway, the lamp will
stay on. The paper will start coming out of the slot.
3.
When the reception is compieted, the unit wiii emit a iong beep.
4.
Cut the recording paper with the received image. Make sure to do so oniy after the
iong beep so as not to affect the quaiity of the received image.
NOTE: Remove a jammed document from the machine by opening the recording paper cover.
Otherwise the receive operation will fail.