0pq-j-j_|^p yg – Brother FAX-175 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Press START/COPY button to enter the selection.

Now, you can change the factory setting of "0" to the optional setting of "1". To enter
"1", press FINE button once. Press START/COPY button to register this choice.
(Note that pressing theSTART/STOP button without pressing FINE/PHOTO button
beforehand, selects and registers a "0"). The unit will automatically print out:

**** DO

YOU WISH TO MAKE THE FOLLOWING CHANGE?

*******

NEW USER SWITCHES: 0000100

**************************0pQ-J-j_|^p yg*****************************

The START/COPY lamp will start to blink.

If your entries are incorrect, press the STOP button and then the START/COPY

button. The FINE lamp will start to blink. This will bring you back to step 4 where you

can select this procedure all over by pressing the FINE/PHOTO button five (5) times
and then going throrough the rest of the procedure.

If your entries are correct, press the START/COPY button to complete the selection

of numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other switches. To do so, you press START/COPY button again which
will bring you back to step 4 above and where you can use the FINE/PHOTO button to
select the desired switch. Choice (2) is to terminate the registration process by
pressing the STOP button.

NOTE: Your entries, e.g., the RTI/TTI and user switch, etc. can be verified by printing out the
SYSTEM CONFIGURATION LIST. We will explain how to do this in a later section.