Iv. user-selectable switch, Parameters they control – Brother FAX-175 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
16
iV. USER-SELECTABLE SWITCH
The FAX-175 offers a number of user-selectable functions via the User Selectable Switches
which are initially programmed as 0000000 by the factory. Each of these digits is a "switch"
that controls a specific parameter of the facsimile machine.
Digits
Parameters they control
Digit 1:
The transmission speed
Digit 2:
The presence or absence of audible tone
Digits 3 and 4:
The resolution mode - NORMAL, FINE, PHOTO
Digit 5:
Length of a document that can be transmitted or copied
Digit 6:
The presence or absence of end-of-page mark
Digit 7:
NOT USED
The following table summarizes the digits, the items they control, the factory settings, the
optional settings and the new codes for the optional settings. Remember, the factory settings
are all Os!
Digit No. Item controlled
Factory Set & Code Optional Setting & Code
1
G3 transmission speed
4800 bps (0)
2400 bps (1)
2
Audible tone
Present (0)
Absent (1)
3 & 4
Resolution mode
NORMAL (00)
FINE (10)
PHOTO (grey scale) (11)
5
NOT USED
6
End-of-page mark
Present (0)
Absent (1)
7
NOT USED
For example, when the factory selected for digits 3 and 4 the setting of 00, the FAX-175 will
automatically select the NORMAL mode as the "home position". However, if most of your
transmissions are of photographs, you may wish to change the "home position" to PHOTO (by
setting the digits 3 and 4 to 11. See below for the procedure.
To set a user-selectable function:
1.
Turn the power OFF.
"CAUTION: BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE EVENT
OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNIT'S MAIN POWER SWITCH."
2.
Turn the power ON again while depressing the FINE/PHOTO button.
3.
The unit will automatically print out:
**** ***********0|jpp^|^-p (J3£p SWITCH SETTING*****************
*
* *
*
USER SWITCHES:
0000000
★
*
* * * * * * * * * * * * * * * * * * * * * * * * * * F A X ~ 1 y^**************************
The FINE lamp will blink.
4.
Select the digit you wish to change and press the FINE/PHOTO button the appropriate
number of times. For example, to select digit 2, press FINE/PHOTO button twice.