Brother EM-430 - Manual (Page 9)

. . ’ i A ' ' ' . C ' i ' O ' ' t ^ ^ ^ ^ ' ' ' " ' ^ ' ' ' / ''"'"0^';', '
Setting up the Typewriter
Set the Power Switch to the ON position. The following should occur:
1. The daisy wheel rotates and stops.
2. The carrier moves automatical ly to the far left end of the platen and then to the preset
or specified left margin.
Notes:
I. Whenever you lift up the top cover, for example to change the cassette ribbon, the
power to the typewriter will automatically go off For this reason there is no danger
in changing the cassette daisywheel or cassette ribbon and correction tape even with
the Power ON.
2. If any of the above didn’t happen, take a look at the section on troubleshooting on
page 46.
Cassette Daisy Wheel
Brother’s slip-in, slip-out cassette daisywheels are known the world over fortheir beautiful
true letter quality type print. Here’s your chance to discover it for yourself
Your typewriter comes with a cassette daisy wheel already installed. You may, at some
point, wish to exchange it for one with a different typeface, or to place a new one in. With
the Brother typewriter, this is a vei-y simple task.
Removing the cassette daisy wheel
To remove the cassette daisy wheel, pull the motor lock lever toward you to release it,
then grasp the ear’ of the cassette daisy wheel between your thumb and forefinger and
simply pull it out.