Removing the old correction tape, Installing the new correction tape, Removing the old correction tape............ i i – Brother EM-430 User Manual
Page 13: Installing the new correction tape............ ii
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting up the Typewriter
Removing the old correction tape
If you need to replace the correction tape, first make sure that the carrier is in the center
of the platen by using the [SPACEBAR] or [BKSP] key. Then remove the cassette ribbon.
Now just pull out the left and right spools of the old correction tape from the carrier.
Installing the new correction tape
First install the left spool, then thread the tape across the left and right guide rollers and
install the right spool. Make sure that the active (non-shiny) side of the correction tape is
facing towards the platen.
Take up the slack by turning the right spool counter clockwise until the white portion of
the tape begins to wind onto the right spool.