Setting start position, Paper thickness control, Start set – Brother EM-430 User Manual
Page 17: Pins, Index, R index, Code, S set, Light, Medium
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic Typing Functions
Setting Start Position
PINS
SSET
Automatic paper insertion normally sets the paper so that typing will start approximately
one inch (25.4 mm) from the top ofthe page. However, you can change this position using
the
START SET
function, so that auto-insertion will set the paper to a start position
anywhere between one and six inches (25.4 and 152.4 mm) from the top of the page.
To set the start position, insert a sheet of paper and press the
[PINS]
key to auto-insert
the page. Now, use the
[INDEX]
and
[R INDEX]
keys to adjust the position of the page
to where you wish to begin typing. Then, hold down the
[CODE]
key and press the
[S SET]
key to save that setting as the start line.
Paper Thickness Control
The paper thickness control is located on the right side of the cassette ribbon table.
The lever is normally pushed right down in its standard position. Pulling up the lever
increases the space between the carrier print head and the platen, thus enabling you to
insert thicker paper and envelopes.
Typing impact may be adjusted according to the quality and thickness of the paper you
wish to use, or to the number of carbon copies you are making.
Select the desired impact force by holding down the
[CODE]
key and pressing the
key for
LIGHT
impact, the key for
MEDIUM
impact, or the key for
HEAVY
impact.
Note:
Your typewriter is able to make up to 4 carbon copies in addition to the original document
cueus