Calling a line format from memory, Text memory, Correction in store mode – Brother EM-430 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced Typing
Calling a line format from memory
END
FORMAT
Once you have stored a line fornnat in nnennory, you can alternate between your custonn
line format and the default line format by pressing
[CODE] + [FORMAT].
The first time you press
[CODE] + [FORMAT]
the format will revert to the default
format. The next time you press
[CODE] + [FORMAT],
your custom format will be
recalled. You can toggle between your custom format and the default format as often as
you wish, until the machine is switched off, when your custom format will be lost.
Notes:
1. You can change the format at any time, regardless off the carrier position.
2. Whenever you press
[CODE] + [FORMAT],
the carrier will immediately move to
the new left margin.
3. The line correction memory will be cleared.
Text memory
STORE
END
FORMAT
This function allows you to store up to 5500 characters of text in memory, and print it out
later. This can be useful if, for example, you wish to send the same letterto several different
addresses, as you can type each address then print out the body of the text from the
memory.
Only a single document may be stored. You may make later additions to the end of the
document, within the 5500 character limit, but once the text has been stored, it is not
possible to make changes to it.
The store mode is selected by pressing the
[STORE]
key, after which the three
PITCH
LEDs
will blink to confirm that your typewriter has entered the store mode.
Now, using the typewriter as normal, type the text which you wish to store.
When you have finished typing, press the
[END]
key. Your type writer will now leave the
store mode, and the three
PITCH LEDs
will blink again for confirmation.
If you need to add additional text to the end of the file after you have finished, press the
[STORE]
key again and continue typing. This additional text will be added to the end of
the file. Remember to press the
[END]
key to exit the store mode.
Correction in store mode
When you are typing in the store mode, automatic corrections can be made to the line
you are typing as normal. The only difference is that when the stored text is printed out