Brother EM-430 - Manual (Page 25)

Basic Typing Functions
Then press the [R MAR] key. The right nnargin is now set.
If you wish to nnove beyond the existing right nnargin to set a new one, press
[M REL] to release the nnargin when you reach it. However, you should first ensure
that the autonnatic carrier return is switched off If it is not, you cannot move
beyond the existing right margin using the [SPACEBAR] as the carrier will return
automatically.
To switch off automatic carrier return, hold down the [CODE] key and press the
[L MAR] key until the AUTO LED above the [TT] key is off
The minimum width between left and right margins depends on the typing pitch,
as shown in the following table.
Pitch Min Margin Width Expand mode
10 20 characters 10 characters
12 24 characters 12 characters
15 30 characters 15 characters
Setting And Using Tabs
Tabs allow you to miove the typing position quickly and automiatically to a preset
position. As their name suggests, they are useful fortyping tables, and are also used
for indenting paragraphs.
Normal tabs
TSET
DTSET
TAB
FIND
Normal (left-aligned) tabs are set by moving the carrierto the position at which
atab is required and pressingthe [T SET] key. To use the tab stop, pressthe [TAB]
key, and the carrier will move to the tab position automatically.
Notes:
1. When atab is to be set in the same position as a decimal tab (see below), the
decimal tab in that position will be changed to a normal tab when the [T SET]
key is pressed.
2. Tab positions are set according to the absolute position of the carrier (in units
of 1/60 in.) based on the left edge, so they do not change even when the
margins or pitch have been changed.
3. A maximum of 24 tabs, including decimal tabs, can be set on your typewriter.