How to route cables, To the left, To the right – Pioneer PDP-503HDE User Manual
Page 49: Bunch cables using provided speed clamps, Attaching speed clamps to the main unit, Attaching and removing speed clamps
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using external equipment
How to route cables
Speed clamps and bead bands are included with this System for bunching cables. Once properly bunched,
follow the steps below to route the cables.
To the left
As viewed from the rear of the display.
System cable
To the right
Speaker cable
Speed clamps
Bead bands
Speaker cable
Speed clamps
Bead bands
System cable
Bunch cables using provided speed clamps
Attaching speed clamps to the main unit
Connect the speed clamps using the 4 holes marked with • below, depending on your routing system.
Attaching and Removing speed clamps
Insert
0
into an appropriate hole on the rear of the Plasma Display and snap
(D
into the back of
0
to fix the
clamp.
Speed clamps are designed to be difficult to undo once in place. Please attach carefully.
Use pliers to twist the clamp 90°, pulling outward. The clamp may deteriorate over time and become damaged
if removed.
Gather cables into a bunch, secure with provided bead bands
I NOTE >
• Cables can be routed to the right or left.
(lD-46