Pioneer PDP-503HDE - Manual (Page 40)

Basic adjustment settings
MENU
ENTER
A/T
Power controi for PC source
Power control allows you to reduce display brightness
and save energy.
Energy save
1 Press MENU.
2 Press A/T to select “Power Control”, and then
press ENTER.
3 Press A/V to select “Energy Save”, and then press
ENTER.
4 Press A/T to select “Save”, and then press
ENTER
5 Press MENU to exit the menu.
I NOTE >
• “Standard” is factory preset value.
• Return to the previous menu by pressing o*^-
Power management
When set, the power will automatically shut down.
1 Press MENU.
2 Press A/V to select “Power Control”, and then
press ENTER.
3 Press A/V to select “Power Management”, and
then press ENTER.
4 Press A/V to select “Model ” or “Mode2”, and then
press ENTER.
5 Press MENU to exit the menu.
I NOTE >
• Return to the previous menu by pressing cf^.
S^cted item Description
Off
• No power management
• Factory preset value.
Model
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the computer and
the signal inputs again, the System stays
off.
• The System turns on again by pressing
STANDBY/ON on the Plasma Display or 0
- 9 on the remote control unit. The System
is out of PC mode. (See page 13.)
Mode2
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the computer and the
signal inputs again, the System turns on.
)-37