Pioneer MJ-D508 - Manual (Page 43)

4
B---. 3
2
3
3
Make sure that if there's a disc in the recorder
that it's stopped.
Press INPUT SELECTOR to select a DAC input.
Each press switches between optical, analog and coaxial—the display
shows the current selection.
Optical — The DAC will convert from the optical digital input to analog,
as well as sending the digital signal to both the optical and coaxial outs.
Analog — The DAC will convert from analog to digital (optical and
coaxial), and can also process the signal using the Digital NR.
Coaxial — The DAC will convert from the coaxial digital input to analog
as well as sending the digital signal to both the optical and coaxial outs.
Press DAC MODE to switch the DAC function
on/off.
The display indicates the current DAC mode.
If in either Optical or Coaxial mode, the display shows the sampling
frequency of the input signal (32, 44.1 or 48kHz), or DAC Unlock if there
is no signal present. In Analog mode, the sampling frequency is always
44.1kHz.
4 If you are converting from analog to digital, adjust
the level using the ANALOG INPUT LEVEL control.
Set so that the maximum signal level is just below the red over area
indicator. If you set the level so that the red level indicators light, you'll
end up with a distorted digital signal.
Switch DIGITAL NR on/off as required.