Pioneer MJ-D508 - Manual (Page 33)

Remote control:
[T] Select/change the character at the current cursor position using the
remote buttons as shown:
: ) GD CD CD
1
: 5 (ZD CD GD
i 5 CD CD CD
1
1 3ER
GD GD GD
Use number keys 1-9 for numbers and
the letters shown above each key. Press
a key repeatedly to cycle through the
letters and numbers on that key.
^0! ■■#$%&■() * + ■/:;< = >?(§)_■
[I] Change between uppercase and lowercase by pressing
DISP/CHARA. The case of the character at the current cursor position
changes between upper- and lowercase with each press.
E] Input the character and move the cursor to the next character position
by pressing ENTER (or by pressing ►►).
0] Move the cursor backwards or forwards along the display using the
◄◄ and ►► buttons. You can't move backwards beyond the begin­
ning of the name, or past the next blank position after the end of the
name.
E] Erase the character at the current cursor position by pressing
EDIT/NO. The characters either side of the current cursor position
close up to fill the gap.
Naming.a Track
Press NAME again to input the disc name and exit
the disc naming mode.
In addition to naming the disc, you can name each track on a disc too. Again, the names can be up to 100 characters long.
2
3
Select the track on the disc you want to name.
You can name tracks in any mode, but if the disc is stopped, the track
must still be selected—use the jog dial or and buttons to select
tracks in stop mode.
If the disc is playing, you must finish entering the name before the track
finishes—pausing playback is a good idea.
Press NAME.
Input the track name
Use exactly the same procedure as naming a disc to name a track.
Press NAME again to input the track name and
exit the track naming mode.