Pioneer MJ-D508 User Manual
Mj-d508
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Table of contents
Document Outline
- MJ-d508
- IMPORTANT
- IMPORTANT
- Features of the MJ-D508 MD Recorder
- Hints on Installation
- About Minidiscs
- Connecting Up.
- Front Panel
- Display
- Skipping Tracks
- Skipping Time
- Fast-Forwarding/ReversSng
- Displaying Disc Information
- Reducing Noise during Playback
- »igital Input
- Recording Using the Analog Inputs
- Reducing Noise during Recording
- Starting a Recording Automatically
- Playing Things Again
- Playing Tracks at Random
- Programming the Track Order
- Playing Non-Stop Music
- Fading Out and Fading In
- Track
- Using a Timer for Future Playback
- Fading In Using a Timer
- Setting the Digital Recording Level
- Recording Over Unwanted Material
- Recovering Lost Time
- Automatically Numbering Tracks
- Manually Numbering Tracks during Recording
- Recording Extra-Long Material
- Recording Fade Ins and Fade Outs
- Using a Timer for Future Recording
- Introduction
- Naming a Disc
- Naming.a Track
- Copying Track
- Tracks
- 7 Go to the track with the name you want to copy.
- Press NAME CLIP to copy the currently displayed name into memory.
- Go to the track that you want to copy the name to.
- Press NAME to start editing the current track name.
- Move the cursor to the position you want to insert the copied name.
- Press NAME CLIP again.
- Use the jog dial to select one of the previous three names stored, then press the jog dial (ENTER).
- 8 Press NAME to leave the track name mode.
- Use the and buttons to adjust the dividing point backwards or forwards.
- Press the jog dial (ENTER) to confirm the divide point.
- During playback of the later track of the two, press II (PAUSE).
- Press EDIT/NO.
- Turn the jog dial and until you see Combine.
- Press the jog dial (ENTER) to select it.
- Press the jog dial (ENTER) once more to input the combination.
- Moving Tracks on a Disc
- Press EDIT/NO while the disc is stopped.
- Turn the jog dial until you see Move.
- Press the jog dial (ENTER) to select it.
- Use the jog dial or and buttons to select the track number you want to move.
- Press ►► to move the cursor to the destination track number.
- Use the jog dial or and »-i buttons to select a new track number.
- Press the jog dial (ENTER) to move the track.
- Reordering Tracks on a Disc
- Erasing a Whole Disc.
- Erasing Individual Tracks
- Erasing a Section of a Track
- Undoing a Mistake
- Writing the UTOC
- T Press EDIT/NO when the disc is stopped.
- 2. Turn the jog dial until you see UTOC Write in the
- display.
- Press the jog dial (ENTER).
- Press the jog dial (ENTER) again to write.
- Make sure that if there's a disc in the recorder that it's stopped.
- Press INPUT SELECTOR to select a DAC input.
- Press DAC MODE to switch the DAC function on/off.
- 4 If you are converting from analog to digital, adjust the level using the ANALOG INPUT LEVEL control.
- Switch DIGITAL NR on/off as required.
- Error Messages
- Troubleshooting
- Specifications